期刊： MATERIALS CHARACTERIZATION, 2021; 179 ()
Stacking faults (SFs) were found at the matrix/reinforcement interface in aluminum (Al) composites in spite of the high stacking fault energy (SFE) of......
期刊： MATERIALS CHARACTERIZATION, 2021; 176 ()
This research explored the mechanisms of increased electrical conductivity in pure copper (Cu) which was first joined with aluminum via micro friction......
期刊： MATERIALS CHARACTERIZATION, 2021; 179 ()
A carbide-free bainitic steel characterized by an excellent combination of mechanical properties is presented here. The transformation behavior of aus......
期刊： MATERIALS CHARACTERIZATION, 2021; 176 ()
We describe here a novel approach of increasing the carbon in austenite via intercritical annealing and consequently derive the benefit of obtaining t......
期刊： MATERIALS CHARACTERIZATION, 2021; 175 ()
Stress-strain responses and twinning characteristics are studied for a rolled AZ31B magnesium alloy under three different stress states: tension along......
期刊： MATERIALS CHARACTERIZATION, 2021; 174 ()
Martensite is a typical hierarchical microstructure, but which substructure plays a major role on fatigue crack growth behavior is still not clear. Th......
期刊： MATERIALS CHARACTERIZATION, 2021; 174 ()
This paper performs a comparative analysis between as-cast and semi-solid CuSn10P1 in a state of a hot compression deformation. Compared to as-cast or......
期刊： MATERIALS CHARACTERIZATION, 2021; 174 ()
Fully recrystallized ultra-fine grained 316L steel with different grain sizes were prepared by high-energy ball milling followed by hot isostatic sint......
期刊： MATERIALS CHARACTERIZATION, 2021; 177 ()
Zinc was added to high-temperature borated and lithiated water and its effect on the oxide film formation, electrochemical behavior and crack growth r......
期刊： MATERIALS CHARACTERIZATION, 2021; 178 ()
The intrinsic flaws of radial gradient heat generation and uneven deformation during rotary friction welding process will damage the structural integr......
期刊： MATERIALS CHARACTERIZATION, 2021; 178 ()
Copper matrix nanocomposites reinforced by Al2O3 nanoparticles were fabricated by accumulative roll-bonding (ARB) processed to ultrahigh rolling cycle......
期刊： MATERIALS CHARACTERIZATION, 2021; 179 ()
Mg-Zn intermetallic layer on AZ31 alloy was prepared by solid-state thermal diffusion under 20 MPa pressure. The surface microstructure, microhardness......
期刊： MATERIALS CHARACTERIZATION, 2021; 179 ()
High speed compression and static compression were conducted on a Ti-10 at.%Al alloy to explore the effects of strain rate and strain on microstructur......
期刊： MATERIALS CHARACTERIZATION, 2021; 179 ()
A novel brazing of C-f/C composites was achieved using AlCoCrFeNi2.1 high-entropy alloys (HEAs) as the interlayer. The microstructure and shear streng......
期刊： MATERIALS CHARACTERIZATION, 2021; 174 ()
Till now, the novel Zn-based alloys have attracted extensive attention, due to the excessive dissolution rate in the Mg-based alloys and the detriment......
